 |
I am currently using this update kit on one of my turret disk die set-ups, and it is a big improvement over the standard hopper. The standard uses sheet metal screws in the plastic bosses of the hopper, a few disk changes and it's stripping out. This uses thumb screws on studs. The adjustable powder measure is an improvement too, but the supplied VMD chart is not very helpful as the increments on mine as checked with an RCBS chargemaster scale is way off. Just throw some charges, weigh and adjust until you get it right. It throws very consistantly, the trick is to not go too fast and use a pencil to graphite up the pot metal chute, this will prevent the powder from sticking.
I just ordered two more for other die sets. (I don't like to fiddle with the charge bar, once set). Oh yeah, you will need to order the Lee auto-disk riser if you are using a turret press with a Lee safety prime system. It needs to go higher to clear it...
Rating:  [5 of 5 Stars!] |
|
|
