Slip 2000 Gas Piston Parts / Choke Tube Cleaner - 16 oz (60080)
MPN:  60080 UPC:   815706000809

Slip 2000 Gas Piston Parts / Choke Tube Cleaner - 16 oz (60080)

Gas Piston Parts / Choke Tube Cleaner will allow you to clean these parts in 15 minutes or less.

The time consuming and labor intensive chore of cleaning your gas system parts and choke tubes is a thing of the past with our Gas Piston Parts & Choke Tube Cleaner.

Slip 2000 Gas Piston Parts / Choke Tube Cleaner was designed with your health and safety in mind. Unlike other products, this product is non-flammable, non-hazardous and it is biodegradable. Gas Piston Parts / Choke Tube Cleaner provides you with a safe effective way to clean carbon and plastic wad fouling from choke tubes and all those Semi automatic shotguns gas system parts.

Simple to use
For best results, on parts that are not cleaned on regular bases, completely submerse parts to be cleaned and allow to soak for 5 to 15 minutes. Remove parts and wipe, brush or rinse clean. It's that easy. Depending on the frequency of cleaning or type of ammo used a second soaking may be required. You may also push a brush or mop lightly through choke tubes and watch the plastic roll out in sheets.

For larger parts that will not fit into jar, soak a nylon brush or rag in CTC, apply to area that needs to be cleaned and allow product to set for 2 to 5 minutes. When ready to clean, saturate brush or rag with CTC again and wipe or brush away carbon. Parts may also be rinsed clean under hot water.

After cleaning, always apply a Slip 2000 Lubricant to metal surfaces and allow to penetrate pores of metal. Slip 2000 will form a barrier and help keep carbon, lead and plastic from sticking. Your next cleaning will take half the time.

Other uses
Shotguns - Pistols - Revolvers - Black powder guns - Automatic weapons

May be used in chambers and barrels as a bore cleaner. Apply to cylinder faces, bolt faces and any other hard to clean areas and allow to soak for 2 to 10 minutes. Carbon, lead, copper and burnt powder will wipe clean with a nylon brush. Next cleaning will be much easier with Slip 2000 Lubricant/Cleaner. Users will actually be able to wipe carbon and plastic wad fouling away.

For best results, on parts that are not cleaned on regular bases, completely submerse parts to be cleaned and allow to soak for 5 to 15 minutes. Remove parts and wipe, brush or rinse clean.


SALES@ABLEAMMO.COM | 1-800-720-3275 | Fri 01 Aug 2014 10:15:50 AM MDT