Carbide 3-Die Sets
Carbide 3 Die Set w/Shellholder For 10MM Auto
Lee carbide dies are contour ground to provide step-less sizing. After sizing a case, except for the burnish, you cannot tell where the sizer stopped. Other brands leave a pronounced step where the die stops. With a carbide sizer, no case lube is needed, and you don't even have to clean your cases.
No need for a taper crimp die, plus better accuracy with Lee Dies. Taper crimp dies are used to correct the problems caused by the improper expanding plug design or adjustment. They distort the bullet shank and reduce accuracy. Because the Lee Expander flares the minimum amount, consistent with easy bullet insertion, all of the flare is removed with the bullet seating die, thus eliminating the need for a taper crimp die.
Each die has an enlarged mouth to dependably align even range damaged cases. They are built to last for the large volume reloader.
Powder Through Expanding Die
Bullet Seat & Feed Die
Carbide Sizing Die
Powder measure and charge table
Mfg Item Num: 90566
Category: RELOADING DIES
Type :Carbide 3-Die Set
Caliber :10MM Auto